Anybody help me with configuring simple PPPoE server for lab purposes? I configured it on old Cisco 2800 router, important parts of config:!
username ppp password 0 ppp
archive
log config
hidekeys
!
!
bba-group pppoe global
virtual-template 1
!
!...
It is a mystery for me. Finally it started to work, but it is not 100% clear for me, how.As I found there were two problems:First - access to the router. My GA interface was connected to the switch as a normal access port. And only with IP created on...
Now it looks promising:Virtual-Access1 unassigned YES unset down down
Virtual-Template1 1.1.1.1 YES TFTP down down
Virtual-Access2 unassigned YES unset up ...
I recreated this template but it seems, mtu is default, didn't type such command, but it is, config looks identical as before. My virtual interfaces are here:Router_Cisco#sho ip interface brief | i V
GigabitEthernet0/0 unassigned YES NVR...