Hello,I'm interested in finding out how people manage tracking of endpoints on SDA fabric networks. Particularly when it comes to seeing the history of a client as it moves on the network and where IP addresses change. I'm talking about on the wired ...
Hello,We have a Cisco SDA fabric with 9300 edge switches and a single 9500 border node, with DNAC version 2.3.3.6-70045. The fabric in question contains a VN with native ASM multicast enabled in the overlay and an IP pool with Layer 2 flooding turned...
Hello, We have a few Cisco Catalyst 3850 12XS switches running IOS-XE 16.9.2 and utilising Stackwise Virtual. We are looking into using the In-Service Software Upgrade (ISSU) feature, but looking at some of the documentation, we are unsure as to whet...
Yes, once we know the MAC address, we can verify where the client is connected and trace it against a user. As I mentioned, the issue we have is where we get given an IP address and a time it was used, and need to correspond that with a user.James
Thanks for your replies. I should note that we're not currently using 802.1X on the wired network, so have no records from that point of view. Instead, the network has no authentication in place.James
Hi Rahul,I know it's been a little while since your reply, but I have finally had a chance to read through the documentation provided and test this on our lab fabric.I have configured the two fabric edge nodes, directly connecting a Shure microphone ...
Thanks for your response Rahul.In this case, the AV devices are connected to different FE switches and a device connected to switch A needs to discover the devices connected to switch B all within the same VLAN, VN and IP pool. From your reponse, I w...
I had a similar issue to this yesterday: We upgraded a pair of 4500x-16 switches in a VSS pair using the bootvar commands similar to the above. Executing 'redundancy reload shelf' shut down the switches but they didn't seem to come back (all status l...
