kronikd22
Level 1
Level 1
Member since ‎10-02-2006
‎08-18-2017

User Statistics

  • 15 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
First Discussion
5 Discussion Posts
10 Discussion Posts
1 Reply
5 Replies

User Activity

Hello, We currently have a 7206 communicating to a 1721 at a remote site. The link is a private/point-to-point 1.544 circuit (HDLC).Down the road, we may want to add another 1.544 link between these two sites to accomodate bandwidth needs. My questio...
Hello,Here is my situation...I have around 20 or so workstations on the 10.79.15.0 /24 network. These workstations use DHCP. These workstations need to communicate with another network, and they need to have NATTED IP addresses. The NATTED IP address...
Hello,We currently have a single Cisco 1841 router that has a few dozen serial subinterfaces(16K CIR each) that connect to remote locations. The traffic going to each location is extremely light (mostly just ICMP and SNMP). Of course, all of this is ...
I am ordering cable for the switch trunk lines of our data center. Is it possible to use CAT6 cable on Cisco switch gigabit ethernet interfaces (RJ45), and does anyone use it in a data center environment? Would you recommend CAT5e shielded, or CAT6?
Hello all,I am planning on implementing rapid-PVST in a data center switch fabric, as recommended by Cisco. However, I am very curious about MSTP. What exactly are the advantages/disadvantages of running MSTP over PVST? Would MSTP be an acceptable so...
Community Statistics
Member Since ‎10-02-2006 06:18 PM
Date Last Visited ‎08-18-2017 03:53 AM
Posts 15