linwei22403
Beginner
Beginner
Member since ‎08-18-2020
‎12-11-2020
Awards
1

User Statistics

  • 71 Posts
  • 5 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
Spotlight Award
1 Accepted Solution
5 Accepted Solution
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

原有两台3850堆叠sw1 sw2现在把sw1 下线了(no switch 1 provision ws-c3850-24xs),仅剩下sw2.show interface 显示都是G2/0/1 ,于是调整sw numeber,将2变为1(switch 2 renumber 1)重启后发现,sw number是改过来了 但是 接口配置也变成了已下线的sw1的接口配置,虽然全局配置,vlan信息,路由信息都在。于是手动将接口配置敲了一遍,才恢复网络,请问有什么命令,或者步骤上,可以直接保留s...
access-list dmz-acl extended permit ip any object-group fhw-sie access-list dmz-acl extended deny ip any host 162.0.215.197 access-list dmz-acl extended permit ip object fhw-Proxy any access-list dmz-acl extended permit ip object fhw-hoping any 想把第二条...
通道显示up ,只是ASA到飞塔的网络通,而飞塔到ASA不通,不知道为什么ASA 可以敲什么命令 来验证哪里出问题了呢
ip access-list extended 100deny ip host 192.168.2.100 10.0.0.0 0.255.255.255deny ip host 192.168.2.100 172.22.0.0 0.0.255.255permit ip host 192.168.2.100 any!route-map 100 permit 100 match ip address 100 set ip next-hop 192.168.3.2--------------...
我现在是 两段私网通过 公网 做IPSec VPN ,用的ASA防火墙。目前两段私网可以互通,但是其中一边的私网 需要NAT至公网,访问Internet,我只要配上NAT,ipsec就不通了,有什么好的解决办法吗
Community Statistics
Member Since ‎08-18-2020 07:50 PM
Date Last Visited ‎12-11-2020 03:52 AM
Posts 71
Awards
Community Spotlight Award
Rookie