About thight

thight · 11-06-2006

We're having trouble with a number of T1's(7 in all) showing excessive Path Code Violations. These lines are delivered via a DS3 and broken out with an Adtran MX2800. The DS3 and the individual T's have been tested by the telco and are clean. The far...

thight · 11-06-2006

Thanks for the info!The MUX is in the same rack as the router. I'm using Cat5 for each T1 coming out of the MUX. Most cable are only 18 inches. Could the cables be too short?- Todd

thight · 11-06-2006

Have not tried powercycling the Adtran yet. Actually, am scheduled to do testing on that unit Thursday. It has redundant controllers so I'm going to swap over to the backup controller and let it run for a few days.

thight · 11-06-2006

I should note that these two interfaces are setup for Multilink PPP but other interface setup for simple HDLC are show the same problems with PCV errors.Here is the current status for the two interfaces: peru-gw1#sh int s 4/2:0Serial4/2:0 is up, line...

thight · 11-06-2006

Actually the remote sites vary in type. All are Cisco routers, some with integrated CSU/DSU some with external Adtran TSU. The only common aspect is that the other ends are not showing any PCV/LVC or serial interface errors. The only errors I see are...

thight · 11-06-2006

Here are the controller and port configs. - Toddcontroller T1 4/2 framing esf clock source internal linecode b8zs channel-group 0 timeslots 1-24!controller T1 4/3 framing esf clock source internal linecode b8zs channel-group 0 timeslots 1-24interface...

Member Since	‎11-06-2006 10:20 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	6

User Statistics

User Activity

Path Code Violations

Re: Path Code Violations

Re: Path Code Violations

Re: Path Code Violations

Re: Path Code Violations

Re: Path Code Violations