About puropuro1

puropuro1 · 12-17-2015

Hello Folks! I have the following topology: PC1 Has as default gateway the virtual ip created on standby group, there's no VLAN than VLAN default VLAN 1 defined in this topology. IOU1 Ip 1.0.0.2/24 // Virtual IP 1.0.0.5/24 Standby 1 priority 150...

puropuro1 · 10-21-2015

Hi to all. I have a networking topology running on GNS3 with IOU. So well, I have 3 swtiches running the same VTP configuration.The server VTP switch is connected to the router that serves as a gateway for these switches.Ok, what I want to know is ho...

puropuro1 · 06-25-2015

I'm trying to test the connection to the cloud on GNS using IOU VM. I set the Loopback adapter on W8, with the .137.1 address. GNS 3 recognizes the lo Int on the cloud, I'm able to plug my router to the cloud with the lo interface. I set the ip addre...

puropuro1 · 06-18-2015

I'm using IOU on GNS3. I have a router plugged to a switch, this switch has 3 vlan (10,20,30)VLAN 30 is the native vlan.Everything is ok about the performance of L2 layer but when I try to add the IP address to the trunk port of the swtch that goes t...

puropuro1 · 06-14-2015

I have a OSPF topology with three areas and the backbone area.On few routers of each area I have connected a set of switches running VTP ans RSTP.So well, what I want to do is share a VLAN on all the switches of the OSPF topology, for instance VLAN 3...

puropuro1 · 12-19-2015

Guys the problem is with IOU Images on GNS3 and not about config, I replaced the Switch that communicates routers on HRSP group 1 and voila! it works, so thank you all for your collaboration.

puropuro1 · 12-19-2015

Check again, I updated this thread with some pics.

puropuro1 · 12-18-2015

Hello again!Herein I am attaching some pics of my devices.

puropuro1 · 10-29-2015

Seb, I'm going to try onepk from Cisco Dev. My problem goes beyond knownledge of command lines, hehe it's about lack of command options due to software incompatibilities. By the way I'm going to tag your answer as correct, without your advice I would...

puropuro1 · 10-29-2015

Seb! don't worry about that running config. I realized both, IOS and Switch are not capable to implement PVLAN on trunking ports, to do so I must change my hardware and software! So I decided to go with the VACL option, in this moment I'm learning ab...

Member Since	‎06-14-2015 03:44 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	16

User Statistics

User Activity

HRSP Unknown Standby Router, Both Routers Active

ACL on VLAN

IOU VM Cant connect to Cloud

Can't assign an IP to the trunk port of the switch connected to router

Any way to pass VTP config to others Switches in other Routers?

Guys the problem is with IOU

Check again, I updated this

Hello again!Herein I am

Seb, I'm going to try onepk

Seb! don't worry about that