About bluebytes1

bluebytes1 · 05-24-2012

Hello,I have two serie 300 switches with 4 vlans created. I normally have one connection between two switches and configured as trunk mode with vlans added to that trunk.Now i want to have a new connection so it will have two links between each other...

bluebytes1 · 04-23-2012

Hello!I have two SG300 serie switches and two Gigabit connection between them. How do I configured these two links to work toghether like a one 2 Gigabit channel?thanks a lot.

bluebytes1 · 03-26-2012

Hello,I want to set up a vlan only for the wifi APs and wifi clients on my network. They can't access to any server, only internet accesI already implement this configuration and its working, but now I want to allowed a couple of laptops to connect t...

bluebytes1 · 03-26-2012

Hello and thanks in advance for your help.I set an SG300 switche in layer 3 mode with 3 vlans.I need to give IPs to a whole vlan machines. Do the switch have a DHCP server per vlan? Can someine help me to configure this?thanks!

bluebytes1 · 03-26-2012

Hello and thanks in advance for you help.I have a SG300 switch working in layer 3 mode. I created 3 VLANS and the intervlan communication is working fine. I want to know how to block acces to switch managment from the Vlans.One of the vlan is allowed...

bluebytes1 · 05-25-2012

Robert, Thanks for your reply.After I have the LAG configure with the ports, how should I set that LAG to allowd vlans i want? like a trunk port where I set vlan allowed.thanks.

bluebytes1 · 04-24-2012

Thanks a lot Brian,yes that is what i'm trying to do. a LAG.I will try the thing you wrote. If i have problems will bother you again.

bluebytes1 · 04-10-2012

David,If I have my core switch in layer 3 mode and several others switches but in layer 2 mode. Where should i configure dhcp relay? All switches or only in layer 3 switch?I have 3 vlans and the dhcp server in other vlan. This dhcp server should gi...

bluebytes1 · 04-04-2012

Davidthanks a lot for your advice. you are very helpful.I try that configuration and it works perfect. Now I'm going to test the dhcp relay of the switch.Thanks !!!

bluebytes1 · 04-03-2012

David, Thanks again for your reply.I prefer to run core switch in layer 3 mode because of the intervlan routing between vlans except vlan 3 for wireless devices. That vlan I think is better if it goes all to the firewall. And the firewall can filter ...

Member Since	‎03-16-2012 02:36 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	15

User Statistics

User Activity

LAG , how to?

How to configure two links between switches SG300

SG300 - Wifi Vlan

SG300 - DHCP implementation

SG300 - How to block managment access

LAG , how to?

How to configure two links between switches SG300

SG300 - DHCP implementation

SG300 - Wifi Vlan

SG300 - Wifi Vlan