Hello,I have a problem when i try to boot my 2811 ISR, i tried to boot also from a usbflash i had the same error. Here is what i get when i try to bootprogram load complete, entry point: 0x8000f000, size: 0x3d240 program load complete, entry point: 0...

I have setup a SPA400 with 4 FXO lines. When I receive a call via FXO port and the call is not answered, then at the next call  that I receive via FXO port , I see the caller id of the previous unanswered call. Is this a bug or I have to setup someth...

I have setup a SPA400 with 4 FXO lines. When I receive a call via FXO port and the call is not answered, then at the next call  that I receive via FXO port , I see the caller id of the previous unanswered call. Is this a bug or I have to setup someth...

Hello,I have a Cisco 2811 gateway with a E1 card installed (used with CUCM 6.1), I set up voice translation rules so that i can have direct lines. The problem i have is that when i call from  landline phone it works great the line is redirected to th...

Hello,I would like to know how can I setup an IR lamp with the Cisco PVC 2300 cameras so that it can be used in low or no lights.Thanks