I figured out the command. i was using an older version of pkt tracer and t wasnt allowing the ip he...

hello, I have made a topology by using one 3560 switch and 2 2950 switches. I have also made 2 vlans...

So what it means is that etherchannel config should only be done between layer 3 switches and these ...

Hello, i have made a topology in packet tracer related to etherchannel configuration. i am using 2 3...

Hi, I been practicing with the configuration of layer 3 etherchannel configuration and i am facing a...

hi, It might be for incase of failure such that if link on side goes down data can still be sent fro...

Hello Henrikp92, Thanks for the reply back. I dont need a routing protocol in this scenario i think ...

Hi Henrikp, ok now its working fine and now all my blocks are getting ips from the dhcp. thanks for ...

Hi jim, yes the vlans are setup correctly and trunked too. ok i statically assigned the ip of 192.16...

Hi Henrikp92, The vlan2 is for dhcp server so why would i put ip-helper address [dhcp address] on th...

Hello Soroush, Yeah i did make a seperate dhcp pool for each vlan and also i used the ip helper-addr...

Hey, I can ping my server from my router the issue is with clients not getting ips from dhcp. do i h...

hi, I have a made a topology in pkt tracer. i have made use of a router and switches. i placed dhcp ...

hi, I been going through some questions to clear concepts and this question about redistribution con...