Hi, i had issue with server boot when i reboot  UCS B460 , the server stuck at POST with  message "Configuring and testing memory". Could please help.

Hi Folks, I tried to boot from a USB my server B series. I insert the USB into a KVM dongle an set the policy as below Local FloppyLocal CD/DVDRemote Virtual DriveCIMC Mounted CD/DVDLocal Disk but didn't work.

hi folks,  I created two vSAN one on the fabric interconnt (vSAN ID = 100) A and one vSAN on the fabric interconnect B vSAN ID (200). I created the same on MDS A (vSAN 100) and vSAN 200 on the MDS B. I changed the vHBA template vSAN from the default ...

Hi Folks, I have the following setup:- fabric interconnect connected to one upstream switch.- mac address of the OS's Blades are learned by the switch but the blades can't communicate to each others.- it s baremetal installation. 

Hi folks ,  I had an issue when failover the ASA from the primary to secondary node. only one group fails to the secondary node.below some outputs. ASA# show failover stateState Last Failure Reason Date/TimeThis host - SecondaryGroup 1 Failed Ifc Fai...