About ajcamachou

ajcamachou · 05-04-2012

Hi All,I already know that there is an option using Patton Copper Link Ethernet extender to interconnect a remote LAN with this device. Do you know if this is possible using Cisco 888-K9 or any other Cisco Device?thanks in advanceA...

ajcamachou · 04-29-2012

Hi all,Please let me know if I am right:I am using a GRE-IPSEC tunnel configuration + EIGRP routing protocol and I would like to confirm if I am right with the following:Due to I am configuring the IP MTU = 1400 in the Tunnel interface, I am avoiding...

ajcamachou · 04-02-2012

I followed the instructions for interconnecting 2 LANs using VPN (I am using GNS3 simulating 2 ASA 5510 - one on each side to build the VPN) but I am receiving the following error (unfortunately, I am not an expert in terms of ASA.ciscoasa2# Apr 02...

ajcamachou · 05-14-2012

Thanks leolaohoo for answering, Unfortunately, Cisco is no more providing LAN extended solutions and 880 devices require using TELCO infrastructure. So, I will close this post.

ajcamachou · 05-03-2012

Hi Peter, sorry for answering so late.I would like to say that I am not an english language native and probably I used the wrong word/expression (sorry about that). I mean by orientation that I followed your instructions/guidance to understand better...

ajcamachou · 05-01-2012

Hi Peter, thank you so much for your explanation. I would like to comment that I am only using is IP MTU + PMTUD between both ends instead of ip tcp adjust-mss, and I got the following results using Wireshark on my PC and generating a TCP connection...

ajcamachou · 05-01-2012

In addition to the previous, I am going to test my SSH connection using Wireshark and access the LAN interface of the Remote Router. By doing this, I will check if the MSS (1360) is effectively negotiated however I am not sure if this is the best opt...

ajcamachou · 05-01-2012

Peter / Joseph, I am very grateful with both, thank you so much. Additionally, I agree with you regarding that UDP traffic is the one being fragmented. However, I would like to share with you the last tests that I made using PMTUD + IP MTU = 1400 on ...

Member Since	‎04-02-2012 12:38 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	21

User Statistics

User Activity

Extending the LAN using Cisco 880 over 1 twisted-pair??

configuring adjust-mss + ip mtu in the same tunnel, affects hsrp?

VPN L2L using GNS3 --> ERROR: Removing peer from correlator table failed, no match!

Extending the LAN using Cisco 880 over 1 twisted-pair??

configuring adjust-mss + ip mtu in the same tunnel, affects hsrp

Re: configuring adjust-mss + ip mtu in the same tunnel, affects

Re: configuring adjust-mss + ip mtu in the same tunnel, affects

Re: configuring adjust-mss + ip mtu in the same tunnel, affects