sphbecker1
Level 1
Level 1
Member since ‎01-31-2021
‎03-23-2022

User Statistics

  • 11 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 10 Helpful votes Received
Recent Badges
5 Replies
10 Helpful Vote
1 Helpful Vote
FirstQuestion

User Activity

My company uses Firepower firewalls in a hub/spoke site-to-site vpn topology and use Meraki wireless access points. That all works as expected and the two platforms don't interact with each other than passing packets.My question is if it is possible ...
I have an odd issue that I can't understand. It isn't exactly a huge issue, but I would like like help understanding what is happening here, because I don't get it. 2 floor office with a Cat9300 stack on each floor. We don't have a huge number of dev...
Our regional offices have Firepower FTD devices (without FMC), each with two VTI interfaces to the data center, routing via BGP. We want to use DHCP Relay to point to a remote DHCP server (due to FTD's DHCP lacking needed config options). I don't wan...
I just installed a new FTD in Azure (standalone, not managed by FMC), running 6.7.0-65. I so far we have done no config, just set set a single static route to access our VNET and enabled management over the inside data interface. Getting a ERR_SSL_VE...
I currently have 18 offices all with Firepower FTD devices as their network edge device, each with a s2s VPN connection to an Azure Virtual Network Gateway (VNG) as a hub. I am testing the idea of using our FTDv in Azure as the hub device instead of ...
Community Statistics
Member Since ‎01-31-2021 10:00 AM
Date Last Visited ‎03-23-2022 12:14 AM
Posts 11
Total Helpful Votes Received 10
Helpful Votes From