Hi All,We have had a interface to WAN drop. When checking the SFP module on 9200L switch the port flashes green then goes solid green. It keeps alternating between these states. Any ideas?This is a previously working port and no config has been chang...
HI,I have a problem, we have a failover fortigate FW pair both linking to a single switch which then has a trunk connecting to our core switch.If I remove the single switch and run the pair of cables from the fortigate into the core then the FW fails...
OK,We are getting a new higher speed WAN connection, at the moment we have a router between the CSU and firewall. The router isnt doing much, couple of static routes and that is all.We dont want to buy a new router for the higher speed (the interface...
I have a switch that will supply max class 3 power but my wifi devices are class 4 power. Will this have an impact on wifi performance, if so why? Just getting more complaints recently with more usage of the wifi.thanks, Chris.
Hi,We had a switch that dropped off the network, when we consoled into it we found it had gone into ROMMON mode.Any ideas anyone.C9200L-48T-4G 16.9.2 CAT9K_LITE_IOSXE BUNDLE The only way to get the switch back was to pull the plu...
Its the providers router connected to the port in question (Ciena Router) but the circuit has been working for 18months.no switchportip address x.x.x.xntp disableendRunning 'sh ip arp' doesnt show the expected IP address with entry for the the other ...
HI,I have my DCA coming up as N.A even though its set to 10minutes automatic, should I be concerned by this or is this expected if a channel change has never occurred ?
