I have 2 3850 switches. One is a DMZ switch, the other on the internal network. I have created a routed port on the DMZ switch with an ip in the vlan of the internal network switch port. This was working great with a 24 port switch. I was able to...
This is a DMZ switch. I created the routed port with an IP from VLAN 10, so I can manage the switch from my network. The default route is the FW. This was all working fine with a 24port switch, but I needed a 4 port 10g module which this switch do...
What's crazy is that if i plug the old switch back, i can access it with no issues. Same config, nothing changes on the internal. (one note, I obviously need to clear the arp).
