Today I was studying the seamless MPLS approach from this page:https://www.cisco.com/c/en/us/support/docs/multiprotocol-label-switching-mpls/mpls/116127-configure-technology-00.html But there is a point where I really struggle.See the picture below.H...
Hello community,I need to establish a L2 VPN over a L3 Network.The Goal is, to span an existing VLAN from a on PE Router to the other.The gateway of this VLAN is also the PE Router (no CE Router). See picture.I currently can only simulate it with GNS...
Hello Community.
During a project we need add new iBGP Routers (N7Ks) to an existing full mesh topology.
At the end, the N7K infrastructure replaces the old devices (Cat 6500) but for some time, the full mesh would be quite big.
From your experience ...
Thank you Harold.I think I got it now. Sometimes you didn't see the forest with all these trees in your way. ;)In this example they redistribute just the loopbacks of RR1 in ospf2 and RR2 in ospf3.LDP neighbor ship, even if it is established between ...
Hello Harold, thanks for your answer.But we have this Edge Router from the picture above.It has one interface to the left with LDP active, and one Interface to the right with LDP active.How can I "disconnect" the LDP protocol on one physical router?F...
Yes the xconnect itself works fine.But my problem is, that my PE and CE Router functionality in on the same devices.xconnect always ends at an physical interface. At least what I have testet. I need a solution where the xconnect ends at a vlan.And th...
Today I face the same problem. We added a Switch to a stack.
Switch Ports Model SW Version SW Image Mode------ ----- ----- ---------- ---------- ----* 1 34 WS-C3850-24XS 03.07...
