hello wonderful people,
I have got a task to complete in few days.
There are around 140 routers in customer environment.
I need to validate it's QOS configuration if it's as per the customer standards.
There are many routers with wrong configuration...
Hi,
i have a cisco 2911 router with 100M ethernet link.
The bandwidth is below 200/255, even than the output drops are increasing.
The CPU process is normal. I cannot find out a cause for the same.
Can someone help.
Thank you for the ideas.
Atleast I have some way to look forward to.
I'll try to do the CPI solution.
However, does that need any configuration on the devices as I cannot make any changes on customer routers. Although I might be able to do SNMP ReadO...
Hello, thanks for your response.
It's below
WAN----GigabitEthernet0/0 is up, line protocol is up Hardware is CN Gigabit Ethernet, address is fc99.47d2.6a23 Internet address is y.y.y.y MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec, reliability ...
I think you would be connecting all your servers to this 3560 switch.If yes, than all your 48 ports are 10/100, so your servers would be connected at 100 mpbs only in that case.You won't be able to connect your servers to SFP ports with your Cat-5e c...