On an SG300 switch, we use the commands:vlan database default-vlan vlan 11 exitBut the default-vlan command doesn't seem to be in the firmware on SG350 switches.  What's the equivalent command?  I can't find it in the web interface either.

We've had this issue for years now and it's about time I dealt with it!We linked two sites together via low latency 100mbps circuits a couple of miles from eachother.  There's a SG300 in layer 3 mode at either end of the link and a /30 subnet between...

I've connected two L3 switches, which each has a different default VLAN.  I've used two interfaces, grouped into a port-channel/LAG, for redundancy and to increase available bandwidth between the two. The configuration is identical on the two switche...

Is there some way of preventing the auto voice VLAN on one SG300 switch from propagating its settings to another SG300?I've got two SG300 switches in layer 3 mode connected to eachother via two Cat 6 cables using a port-channel.  Each end is configur...

25-Jun-2015 08:44:45 %BRG_IGMP_QRR-W-DUPLICATE_IP: Duplicate IGMP Querier IP address 192.168.142.1 detected on VLAN 1. Remote MAC address is 34:a8:4e:0d:34:55. I am seeing this regularly on this SG300-28P switch.  These IP and MAC addresses belongs t...