Network1Operations
Beginner
Beginner
Member since ‎06-22-2015
‎08-18-2017

User Statistics

  • 11 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received

User Activity

Is there a way to change the MAC address on a single port on a SG300 switch? I have a setup similar to this:https://farm6.staticflickr.com/5564/14352098480_9a2eb52af0_o.pngbut with two dynamic IP WANs. I am finding that both my WANs are binding to th...
I have two issues.First, my SG300-10's default IPv4 route keeps defaulting to the lowest numbered subnet I put on the switch. I'm using 10.xx.xx.0/24 subnets. My VLAN1 is on 10.90.90.0/24 subnet and VLAN11 is my WiFi guest access with 10.11.11.0/24 s...
In the IPv4 Static Routing Table below, The switch is assigning a VLAN (and associated subnet) to a subnet/route that has zero access to my management network. How do I change the Default Route to VLAN1 and the subnet associated with VLAN1? This is a...
I have a UniFi WAP that I'm fine getting it set up on the default/native vlan1 with the smart ports left to the default settings but as soon as I move the thing over to a port with a vlan it can't associate and everything goes down hill from there. D...
This is probably more of a generic networking question than a Cisco specific question, I am trying to configure a SG300-10 switch in L3 mode so that the switch can handle certain types of traffic across interfaces (and subnets) without the need for i...
Community Statistics
Member Since ‎06-22-2015 04:16 PM
Date Last Visited ‎08-18-2017 03:53 AM
Posts 11