About josephsmar

josephsmar · 01-29-2015

I am hoping some has set this up already, but I have not been able to find any examples in this forum or on the internet. What we are trying to do is setup a port channel from our nexus 7k to a F5 LTM load balancer. The links are two 10gig. One thing...

josephsmar · 05-21-2015

To fix it I would go with TAC is telling you, unfortunately. If you are looking to mitigate the issue you may be able to power off that fabric module until the replacement can be put in. Sorry for the bad news.

josephsmar · 02-24-2015

Actually I had Lacp configured on both sides. I tried all the combinations possible and it never would work. I also turned off flow control on the f5 at the same time so that may have something to do with it as well. I am going to play around with th...

josephsmar · 02-23-2015

Bilal, I actually took lacp off and they came up fine. I just have to finish testing to make sure it passes traffic like it is supposed to.

josephsmar · 02-20-2015

So this is what I get when I setup the F5 and Nexus the way you said to. Also I am not getting a mac from the port-channel anymore. I was getting one when I had the standard PO config with one port in it. show port-channel summary Flags: D - Down ...

josephsmar · 02-02-2015

If I may, why put the spanning tree port set to edge? Also if we are running spanning tree in MST what would the F5 need to be to get this to work?

Member Since	‎01-10-2007 12:56 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	13

User Statistics

User Activity

Nexus 7K port channel to F5 LTM load balancer

To fix it I would go with TAC

Actually I had Lacp

Bilal, I actually took lacp

So this is what I get when I

If I may, why put the