Hi all, I am trying to set up Layer 3 handoff between cisco border node on one side and pair of FTD in HA mode on the other. The problem is that DNAC uses /30 subnet for P2P connectivity and I need minimum 3 IPs to use ( 1 on switch and 2 for active/...
Hi all,Has anyone successfully implemented epvn/mpls between asr1001 and asr9000. My test setup is following:Two asr9000 connected to each other with few working bridge domains configured. Software is 6.7.2Two asr1001 (Fuji 16.9.6) are bit connected ...
Hi all,
I am looking in the data sheet for the Cisco CPAK 100GBASE-ER4 Lite Module as it says that supports distance up to 15 miles (25 km).
As well, it is stated by Cisco :"The module can be used over longer distances in engineered links with ...
Hi,
when you say "the first ISP goes down" what do you mean by that? Is it the physical link or ISP network? If it is the latter, then the problem that you have is that ISP router is still active and the route on your 891 is sending traffic there....
Outgoing interface is the one where you want to send all traffic to. e.g. if you have a core switch connected with gig0/0 to you FW and your FW is connected to your Internet router. On the switch the outgoing interface is the one pointing to the FE (...
Hi,
you can
1. configure static default route and redistibute it into EIGRP
or
2. use summary address
RTR(config)#interface gigabitEthernet x/y #outgoing interface
RTR(config-if)#ip summary-address eigrp 1 0.0.0.0 0.0.0.0
Please don't forg...
