About kevint128

kevint128 · 01-25-2007

We are having problem getting our point-to-point T1 connection up and running for a while now. Our service provider ran test on the circuit, but found nothing wrong. The two routers we are using are Cisco 2821 (Site A) and Cisco 2610XM (Site B). B...

kevint128 · 03-13-2007

Both sides are set to line as the clock source. There was nothing wrong with configuration, it was just a bad router on the other end. We ended up swapping out the router at the remote side and it's back up and running again.

kevint128 · 01-26-2007

I tried stripping the config down to bare minimum with no luck. Seems like only one of the sides is not seeing the loop and it just my luck that it's the remote side. Is there anything else I can try to narrow down what's faulty?Thanks for all your...

kevint128 · 01-26-2007

I just put it into loopback on each side and the line is still down and looped. The SHOW CONTROLLER T1 on the other side looks similar, it has a bunch of path code violations. AT&T hasn't been much help with this problem either.

kevint128 · 01-25-2007

Could all these errors caused by faulty hardware? If so, how would I go about testing what's faulty?

kevint128 · 01-25-2007

It's a full T-1 line. I did a show controller T1 and it is showing T1 0/0 is up. Applique type is Channelized T1 Cablelength is long gain36 0db No alarms detected. alarm-trigger is not set Soaking time: 3, Clearance time: 10 AIS State:Clear L...

Member Since	‎01-25-2007 01:17 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	7

User Statistics

User Activity

Help with T1 p2p issue

Re: Help with T1 p2p issue

Re: Help with T1 p2p issue

Re: Help with T1 p2p issue

Re: Help with T1 p2p issue

Re: Help with T1 p2p issue