I found problem but didn't find a solution.
-Problem
It uses a mix of F2 + M1 module, and it is a problem that occurs when port-channel is set.
As the module comes alive,we can confirm that VDC state change will affect control plane pkt(OSPF hello) ...
Hello, Everyone There was a problem with the nexus chssis module, so OIR was performed. While checking the progress of OIR, I checked that OSPFv3 went down and then went up. If anyone has the same or similar problem as me, could you please tell me th...
hello, everyone IOS logging origin-id hostnameI have a question regarding settings.I am trying to compare by packet capture against hostname system log.It worked fine on the nexus, but on the catalyst there is a problem. Catalyst does not leave hostn...
hello, everyoneI have a question regarding spanning trees. The 6500 chassis are all routed ports.L2 is all switch ports.1. It consists of full mesh at this time, but can spanning trees occur? or looping ? 2. And when the port where L2 and 6500 chas...
Hello, Thank you very much for your reply. Is there any documentation I can refer to if that's okay with you? Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0Queueing strategy: fifoOutput queue: 0/40 (size/max) Is it correct to ...
hello, Currently, there is talk that it may be a module type problem. (m1 or f2e) and Since M1 is an EOS module, it is not possible to test in TAC, so we plan to test it internally. If you want the test results, we will share them later.
Thank you for your time. Current information. Model -------- ------------------ -VS-SUP2T-10G S----- ------------ ----------15.4(1)SY string command was used, but syslog was not output.
