Thanks of the help in advance.I am trying to do a simple show command with CLI Templates#MOD_ENABLEshow run int Gi0/0/1 | inc band#MOD_END_ENABLEI keep getting the following error.Error occured while executing the command show run int Gi0/0/1 | inc b...

Well, I loaded the wrong IOS on a 3650-X (SM-X-ES3-24) module. I loaded the IOS for a SM-ES3-24... Now I'm stuck in a boot loop and can not break the boot with CTRL+BREAK... Does the following over and over... Any ideas? Using driver version 3 for me...

I have a sm-es2-24 in a 2911.  I am getting the following in syslog:%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/25, changed state to up%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/25, changed state to down%LIN...

Is it possible to get module information from a 2811?My ISO is, Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(21) RELEASE SOFTWARE (fc1).My 2811 has both a 9 port and 16 port module. When I do a snmpwalk I get the follo...