Hello, Is there a way to configure a WIC-1T serial interface to terminate an ISP provided DSL line? I have another WAN site with an 1841, but terminating a DSL via a WIC-1ADSL-DG. Thanks in advance!
I have been trying to cut-over a customer site from a thomson DSL modem into cisco router fast ethernet connection........to a DSL/MER link directly into a cisco 2811 DSL wic card. All attempts (various configs) have failed thus far. Two questions...
I am trying to configure a channelized E1/PRI port on a Cisco 2851, connecting to a E1 (1984kb). Can anyone provide an example or a reference on the configuration? Thanks in advance!
I am currently working for a client that has a primary MPLS WAN, but is requesting to have DSL redundancy in case of MPLS circuit failure. They are firm on this. I have one site currently up with redundancy via VPN tunnel over DSL...routing with BG...
I'm connecting a 1240AG access point to a Cisco 2960 via 802.1Q trunking. The AP (access point) has a BVI1 interface address of 10.19.28.20/24, and it's default-gate is 10.19.28.1 and DHCP requests are handled by the private network's DHCP server. ...
Sorry....it's for Data. The site has an E1 MPLS circuit. This router will be the redundant E1/Data IPsec tunnel backup route. I have the local ISP static addressing info with gateway
I spoke with Cisco. You were correct, the licensing appears to be the reason for failed/latent connections. Even though the 501 allows for 32 DHCP addresses, only 10 active connections will be allowed through the firewall at any one time. Thanks f...
I think you may be on to something with the licensing, which is only allowing 10 inside hosts. I am researching this and will let you know how it turns out. Thanks for the response!
