Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, my googling skills may not be working correctly.I am hearing from alot of NSX admins stating that ACI can not do micro-segmentation between host in the same network behind vDS. That is where NSX comes into play. Creating the segments inside NS...
I'm new to ACI so please forgive me. I have multiple BD EPGs that are connected and have subnets. Inside the subnets I can ping everyone. But I would like to have EPG 1 reach EPG 2. They are in the same VRF. Typical routing is placing static routes ...
There are 2 places to put subnets inside the ACI model Bridge Domain and EPG. What are the differences of placing them in each section? Tenant / TN-Name / Application Profiles / APP_Profile-ID / Subnets and Tenant / TN-Name / Networking / Bridge Do...
I’m new to ACI. So where I’m at, I have connected up 2 Leafs in VPC to my 2960 switch. By that I am able to see is CDP traffic on the 2960 to the leafs. What I’m not getting is how do I get the VLAN on the 2960 to the ACI environment? I’ve looked up ...
It looks like I have Policy Control Enforcement Preference to Unenforced. Question, What does the EPG Subnets and Bridge Domain subnets do? Do I need to have one for each and different IPADDR on each?
I was able to ping the gateway of the VLAN/Subnet/EPG from the switch this morning after placing the gateway on the Bridge Subnet tab. I thought I had done this already, but I had started over a few different times to cleanup. https://aci-lab.cisco...
That is the example that I am following. It allowed me to connect the VPC and show the CDP. How do I get the EPG extended working? Is there anything special I need to do to the 2960? I example I have vlan 10 with IP Address of 10.1.1.10/24. But unabl...
