Hello everyone, am kind of new to Meraki and my client intend to migrate all our present distribution switches from CAT.4506 to MS250. I need every suggestion that could help during the migration. Each of this Catalyst switches has lot of configurati...
Hello Everyone, I am kind of new to Meraki dashboard. I noticed a down tine of less than a minute on all my Meraki Access switches connected to my dashboard earlier hour of today around 1am. I checked the MX95 to see if theres any upgrade that could ...
Hello Guys I have 2 of my distribution switches Vlan 10 port appearing as Vlan1 against original switch access vlan, what could be the problem? I just noticed this after the switch was upgraded and some clean up on the switch interfaces. Thank you, E...
Hi guys I need your in-depth contributions and recommendation to see if theres is any better Meraki switch to do core(routing), aggregation, software capability, extensive layer 2 and 3 switches as 9k switches or better. I actually suggest MS425, eve...
Thank you David the configuration looks good all the Vlans are running on the switch. but when i do show interface Trunk i noticed Vlan 1 was 'allowed and active in management domain also vlan 1 was 'in spanning tree forwarding state and not pruned
