As my options seem to dwindle I'm looking for some help, a recent reboot of a switch, and it failed to come back up. I can connect to the switch via the console cable if i connect under the standard 38400,8,n,1, no flow, I get no con...
I recently purchased this router Version 2.0, Latest Firmware has been applied, and I am trying to enable the remote management function, every time i try to enable it, a message box comes up stating that i need to change the default password.Message...
After many hours of forum reading and firmware posts, I finally found a post that mentioned trying to connect to a cisco switch at 9600 baud. figured since i was out of just about all other options, it couldn't hurt to try.Connected at 9600 baud on ...
Odd, thought I posted this already but on 06/17/2011 i updated the firmware on WRVS4400Nv2 to version 2.0.2.1 Rebooted the routerDisabled IPSThe following morning my internet connection was randomly dying, followed by the network going unresponsive a...
Unfortunately the switch is pushing just over 5 years, so the typical support methods are out the window.Is there any kind of hardware reset switch built into these things? I'm really running out of options, any ideas or suggestions would be great, i...
This new Firmware doesn't appear to be the answer, I was up and running for just over 80 days on 2.0.0.8 with IPS turned on. I upgraded to the 2.0.1.3 yesterday around 4:00PM and today I am not able to access the routers web interface, nor is the DHC...