We have around 25 branch offices in the nation, each with its own CSS and dial-patterns. Even though anyone can dial a person inside the company using their 5-digit extension, people still call each other using their direct 10 digit number. What can ...
So in our DMVPN network, we have this Cisco 3845 hub router that is connected via a DS3 to the Internet, and our spoke sites usually have a broadband connection that typically have a maximum of 1Mbps upload capacity. We are getting ready to add a few...
(This one if for you Andrew .I may have closed out the previous discussion just too soon. Here is the link for reference:https://supportforums.cisco.com/message/3153010#3153010The issue now is that even though I was able to configure a static IP on t...
I am looking for a solution to run my organizations Blackberry units over the newly laid 802.11n Wireless infrastructure using WPA2/AES authentication. The service provider is T-Mobile and it has the ability to hookup the BB units over WiFi allowing ...
I have an AP that has joined a WLC previously. I want to move it to a different LAN segment and assign it a static IP address. How can I configure this AP? I tried using the CLI,AP#lwapp ap hostname testAPERROR!!! Command is disabled.AP#clear lwapp p...
Thanks! This trick worked for me on the following router:
Cisco IOS XE Software, Version 03.15.01c.S - Standard Support ReleaseCisco IOS Software, ISR Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 15.5(2)S1c, RELEASE SOFTWARE (fc1)
cisco ISR445...
So, consider CUCM running 7.1(2) with sufficient number of DLUs available. In the near furture, an upgrade to CUCM 8.x is anticipated. What would be the recommendations for users that have :1. A phone (let's assume a 7960) with a Unity voice mailbox....
Did you ever get this one resolved? I am having similar issues with my LAP1142N. I am trying to put it back on a DHCP assigned address, but cannot figure out a way to get the AP do that. I had assigned it a static address, ran into the issue that you...
