Hi guys I am needing help setting up a cisco 891W router for wireless at my house.I can get it setup to my modem with wired connections though I am a bit rusty on the Commands I saved my old config file.On the wireless side though I am havin...
Hi,I just setup my homelab today, after having Cat5e installed so I can run my servers and network equiptment over wired network as well as setting up a wireless system. I got everything setup and its going great I can access everything...
Hi,I have been on break for a few months, but now starting to mess around with networking stuff again. I have been waiting on wiring guys to come setup my house with Cat5e, and they finished this last night.I have a 12 port punch pannel (only using 6...
Hi I have a home lab network that is connected to my internet. I basically have a linksys router connected to cable modem and in order for my families internet to not go down while testing and learning my CCNA I am trying to treat the Linksys as th...
I am trying to remove a static route I added:-------------------------------------------------------------------------------------------------r2#show ip routeCodes: C - connected, S - static, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP...
ah well none of it works..... I follow directions from all these pieces of informaton for the router and nothing works. I will see if I can buy a service contract to get cisco techs to configure the router for me. I am really disapointed in the new...
Ok thanks I will go check it out. I may have found a clue about the vlan1 going down though I dont understand it yet.I found this link http://www.dslreports.com/faq/15257and down the page for 881 I started looking at the parts just about the wlan-ap...
well after all that still not working... CISCO documentation pretty much sucks I am really disapointed in the IOS and and configuration of their routers. I am going to see what I can find on the 1800 series routers now as their routers are similia...
everytime I put the dot11 ssid under vlan it goes down.....ap#conf tEnter configuration commands, one per line. End with CNTL/Z.ap(config)#dot11 ssid myssidap(config-ssid)#vlan 1ap(config-ssid)#*Jun 6 19:03:18.871: %DOT11-4-NO_SSID_OR_NO_VLAN: No SSI...
Not sure what happened but it just came up out of the blue...===================891W#show vlansNo Virtual LANs configured.891W#conf tEnter configuration commands, one per line. End with CNTL/Z.891W(config)#vlan 4891W(config-vlan)#name wireless891W(...
