guillaume.chartrand
Level 1
Level 1
Member since ‎05-03-2006
‎04-10-2019

User Statistics

  • 37 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
20 Replies
10 Replies
5 Replies

User Activity

Hi,i try to setup a mesh network (bridge) to connect two building together. The mesh network goes up successfully but can't pass anything over the other building.Here is my setupWLC5520 version 8.5.160Two AP 1562D, one as RAP and one as MAP, both eth...
Hi, We have a problem with vlan tag and we want to know if it’s the way we build our network who’s incorrect of if it’s the function isn’t fully supported on our equipment. We have a core switch Catalyst 3750 with ip service activated, so it’s the co...
Hi, I have a Cisco Catalyst 2960X-48LPS-L iOS version 12.2(55r)SE I have a port linked to another switch (D-Link DGS-3120) The config of the port is only switchport access vlan XXX I suspected some loop on the link so I try to activate the "down-whe...
Hi, I have a Cisco 6509 Chassis with these module inserted 1   10  WiSM WLAN Service Module               WS-SVC-WISM-1-K92    8  8 port 1000mb GBIC Enhanced QoS        WS-X6408A-GBIC4   48  CEF720 48 port 10/100/1000mb Ethernet  WS-X6748-GE-TX5    2...
Hi, I know that many years ago the questions was asked but I want to know if now Cisco have a Cisco ip phone model who's sealed and are water resistent. We need to install some phone in food laboratories and might be splashed with water when we clean...
Community Statistics
Member Since ‎05-03-2006 10:08 AM
Date Last Visited ‎04-10-2019 03:31 PM
Posts 37