About Charles_Chi4

Charles_Chi4 · 02-28-2011

Hi all,I got one problem with cisco ACE in my company. Currently, two ACE appliances are working as HA redundancy. Previously I enabled some https and http probing using get 302 for some servers and services. But then I was told to remove all https o...

Charles_Chi4 · 12-21-2010

Hi,I want to ask if the ACS accounting can be used to log any changes made in web base configurations like ASDM / PDM (for FWSM and ASA) and ACE web GUI. As I know that ACS accounting can log all the change made in CLI.Warm Regards,Charles Chia

Charles_Chi4 · 09-03-2010

Hi,I have a problem in configuring two pair of backup interface on my customer's router (3845). It's ok when I configure just one of them. If I configure both pairs of interfaces into backup interface, one of them will be in disabled mode, as shown b...

Charles_Chi4 · 05-20-2010

Hi,I have problem in my first POC of WAAS mobile today. I just installed the application the same as the document said. I started IIS service first and verified that service run before I installed WAAS mobile. After the installation done, I check tha...

Charles_Chi4 · 05-05-2010

Hi all,I just want to ask if ASA can perform like lock & key like router's IOS security feature???The point is I want to put ASA as the access control between 2 internal departments. I want the ASA to be transparent so there's no hop and no NAT betwe...

Charles_Chi4 · 03-06-2011

Hi Daniel,I just corrected the cert problem and made the state peer into standby hot. But still it still keep probing the get 302. And then I tried to restart both ACEs. The first step is to restart the second ACE (standby) and then switched over all...

Charles_Chi4 · 05-20-2010

Hi ken,It's wierd that it's now in healthy state without me doing anything. I'm going to do testing if it's working well or not. Below is the info for you.1. There is 1 type of error in system :Event Type: ErrorEvent Source: DCOMEvent Category:...

Charles_Chi4 · 05-05-2010

Hi PK,When u said that the ASA proxy will match the traffic on ACL defined in matched statement, it then will be authenticated. The acl before is only just used for triggering the authentication right? and after the authentication is successful, ASA ...

Charles_Chi4 · 12-30-2009

Hi Eric, There's no network flapping issue at all. I just found that the WAAS on those sites having the same minor alarm severity information : "The TFO accelerator is overloaded (connection limit)"Is there any other workaround than just restarting o...

Charles_Chi4 · 04-05-2009

I've already cleared the counters several times and it still shows increasing number on the unknown protocol drops. It even show up in the LAN interface. The LAN itself is simple. Is there any document that can give justification of what can make the...

Member Since	‎04-19-2007 08:24 PM
Date Last Visited	‎06-03-2020 06:20 AM
Posts	59

User Statistics

User Activity

ACE keep probing real servers using "https get 302"

[ASK] ACS accounting for WEB GUI configuration change

[ASK] Disabled in backup interface???

WAAS mobile server status is unreachable

ASA act like router's "lock & key" ???

Re: ACE keep probing real servers using "https get 302"

Re: WAAS mobile server status is unreachable

Re: ASA act like router's "lock & key" ???

Re: [ASK] Could WAAS promote duplicate mails received by users o

Re: unknown protocol drops