Hello,i have Cisco NCS5504 Router with Cisco IOS XR Software, Version 7.7.2.im trying to connect two ports togother internally from the Same Router, lets say its Port 1 and 2, if i send something to port 1 it will forward it to port 2.in my Case i h...
Hallo everyone,I want to ask from your Experience with out of band management Solutions, what is the best Solution if the Primary management (inband)connection failed, what is most used Solutions for such a Situation, i know there are devices with LT...
Hallo everyone ,i have a 10 G interface for Core Device (Catalyst 6880), i want to check if everything ok on this Interface , but theres hight Output Drop Number i dont know if this still normal in compare with all Output Packets ?? , this interface ...
Hallo all,i have a Viavi T-Bird/MTS-5800-100G Tester, it work with Loopback Device (Viavi NCS-100), The problem when i measure i can see just the Download of my Measurment , did any one have experience with this Network Tester ? i think the Reason is...
i want to test what can i see on my Measuring device which information, and i mean to make like single loop traffic test.Measuring device-->Cisco NCS5504 --> the same Measuring device but on another Module like this can i make like loop to test using...
hi Flavio,it not has the command switch port, and i didnt put ip address on any port case i want to use it for Layer 2 .the only thing i tried until now, i made a xconnect grout p2p, and i put these 2 interfaces in this group, after this i config on ...
Hi balaji,thanks for your Reply, in my case its a large Network, and im not sure what is the best way to plan the OOB management, and what is the best alternative connection for the OOB, what would be your advice from experience in such Situation?1- ...
