Hello. I need to implement the command  "power  redundancy-mode redundant" on my 7K. I have enough power and supplies etc that I should be OK with doing it. But what I cant find is if the chassis needs a reload after this command? Bob

Hi everyone. I am monitoring a 3064 Nexus chassis with SNMP, and I am always getting "interface discards in" on one of the port channels. However this is normal due to an ACL in place. When I look at PO1 it shows the discards:  RX    37188296587 uni...

Good morning. Our company is facing a slight dilemma. All our installs seize an outside line using 9, then a 10 digit number. Now I am told that in Maine, the law will be that users must dial 911 directly, not 9,911 like they currently do.  My questi...

Hi there. We are currently running cm 6.x, but are in the middle of an upgrade to 8.x. meanwhile I have to keep the old system running.  Yesterday we had a pub failure, and all our agents were unable to log in because the 'services' button wasnt work...