About ReidJones

ReidJones · 03-30-2017

Hello, I have a Meraki router with a SG300 switch and 2 x WAP561 Access points on ports 47/48. We currently have VLAN 1 (192.168.10.0/24) setup as our main network. I have setup another VLAN for our guest network on our Meraki router, VLAN 50 (192...

ReidJones · 03-20-2017

Hello, I have a UC520 which I have just placed a Meraki MX64 security appliance in front of. I'm now having issues with inbound calls. Outbound calls work fine. Please see the logs below and let me know if you can see what is causing the error. T...

ReidJones · 02-09-2017

I have a UC520 which I'm trying to configure. We are switching to a new ISP who requires that the WAN (FE 0/0) port be tagged with VLAN 35 and then the PPPOE dialer (Dialer2) connected to VLAN35. How should I go about setting this up. Thanks!

ReidJones · 02-07-2017

We are in the midst of switching from one ISP to another. I received the router and need to put it in front of the UC520. My only problem is that inbound calls aren't working. I ran the logs and found the following error. Is there an easy way to ...

ReidJones · 09-29-2014

I have 2 x Cisco 7925G phones that are running 1.4.1 SR1. If I upgrade the phones by USB to 1.4.5, will I run into any issues. I can't upgrade the firmware through the UC520 since its newer than the software pack. I guess the same question would a...

ReidJones · 04-11-2017

Hi Kris, I have 2 SSIDs, one main, and one guest wifi. Guest wifi members should have access to the internet only. On my Meraki router, I have the the ethernet port connected to the SG300 setup as a trunk, the native VLAN setup as VLAN 1 (main net...

ReidJones · 03-21-2017

I can do that. Which debug command should I be using to get the logs requested.

ReidJones · 02-10-2017

Thanks for the help. That should have done the trick but I'm now left with a new problem. We have our fiber line coming in from the ISP, it goes to a TP-Link MC220L fiber converter, then over a CAT6 cable to our UC520. As it turns out, the MC220L ...

ReidJones · 02-07-2017

I have a Bell / Sagecom router hooked up to our new Fiber connection. Behind that I have our UC520 that we've used for years. I changed the internet configuration on the UC520 from pppoe to DCHP. The full debug is below: -------------------------...

ReidJones · 02-07-2017

Thats the IP address of the router supplied to by the ISP (in front of UC520).

Member Since	‎02-24-2010 08:23 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	43

User Statistics

User Activity

SG300 / WAP561 Guest Wifi Help

UC520 - Inbound Calls Issue

UC520 VLAN on WAN Port

UC520 - Inbound Calls Don't Work. Outbound Works Fine

Running Newer Phone Firmware than Software Pack Allows

Hi Kris,

I can do that. Which debug

Thanks for the help. That

I have a Bell / Sagecom

Thats the IP address of the