is the Embedded Packet Capture supported on IE2000 switches? I see the command available on an IE2000 switch that is running a 15.X code but the I am not able to collect any packets when configuring the buffer and the capture point. monitor capture...
I see in the release notes that the IE 1000 supports MST but there is now mention whether it supports Rapid-PVST or not. Does someone have the hardware and can check if other modes of spanning tree are supported?
Hi Everyone,i am having a bit of an issue. I have a group of 1142N APs that are controlled by a 4404 controller. After joining the controller i configured those APs with a location, a static IP and a Hostname.The problem that i am facing is when the ...
i believe your best options is to use:
show ip rpf <ip address>
which should show you the reverse path from the ASA to the IP address you specific. You can choose different ip addresses that exist in different areas of your topology and based on the...
You should translate your MAC address to binary and look for the 7th bit. It seems to me that you are looking for the 1\0 in the hexadecimal format of your MAC.
if we look at your MAC address B8 = 1011 1000. The bolded bit is the one that should be ...
you will need to set:
Service-Type: Administrator
Cisco-AV-Pair: shell:priv-lvl=15
--------
Khalid
If this helps you and/or answers your question please mark the question as "answered" and/or rate it, so other users can easily find it.
Hi,Can you reach/ping your tftp from the 2960 switch?Do you have the ip default gateway on the switch pointing to your core?When you try to tftp does it give you this output !!!! Then ... Then !!! Then .....Sent from Cisco Technical Support iPad App
Check the security on the 2960 switch port...show port-security interface fa0/1... It might be configured in a way that allows a certain number of MAC addresses to be connected.Sent from Cisco Technical Support iPad App
