mohdibrahim01

HiWe had fresh from scratch installation of CWMS 4.0 250 users on perm .using OVF (Cisco-Webex-meeti...

Hi jaime , can you explain with is the requirement to use TRP or MTP and if their any alternative so...

Hi, we have CUCM cluster version 11.5 and for business partner ship we need to connect to our new pa...

Hi Brandon, i check the DTMF method on both dial-peers that pointing to CUE and they match both of t...

Hi, I have configured a basic AA on our site. when i call the no. from PSTN, welcome prompt is playe...

Hi Manish now i can only export call traffic report in PDF format only .in same CCM version Thanks, ...

Hi, we using CCM ver.9.0 and i used to generate call traffic report from Cisco Unified CM CDR Analys...

Hi Vasilii, you was correct it was issue with router RAM and we going to replace the router it self ...

Hi, we had power failure it cause all network equipment to reload but the Cisco router 2811 didn't c...

Hi Alex,we are using SPA 520 IP Phones so that's i can only disable the web access from the phone it...

Hi,we are using UC560 for IP Telephony system and i received complain from end users about that any ...

Hi,we have Cisco call manager ver.6.1 and i have configure 7985 iphone it get registered and every t...

HiYou have to upgrade to CME 9.0 because ATA 187 is only been supported from this version.RegardsMoe...

Hi All,i upgrade the UC500 and reconfigure it from scratch now its working fine .Regards Moe

Hi ,I have Cisco call manager version 6 our end user request to limit the number of incoming calls f...