I am facing a strange issue in which the same vlan host can't ping each other but when on the trunk it's pingable. even inter-vlan routing rule is configured on the firewall.ERP_Server------switch---trunk_link----switch-----PCwhen the server and pc a...
I have two switches in stack 3750x and following message is shownError Message PLATFORM_STACKPOWER-4-CABLE_A_CURRENT_IN: Switch [dec] stack powercable 1 inward current is over the limit Any solution and what is reason
%SW_MATM-4-MACFLAP_NOTIF: Host c84f.86fc.0004 in VLAN 10 is flapping between port Gi1/0/28 and port Te1/1/1%SW_MATM-4-MACFLAP_NOTIF: Host c84f.86fc.0004 in VLAN 1 is flapping between port Te1/1/1 and port Gi1/0/47what could be the reason for this, al...
I have a big network on which switches are connected with single-mode SFP-LR fiber 10G fiber and only a few are on GE, So I want to implement on uplink ports to mitigate or stop the broadcast traffic as below interface TenGigabitEthernet1/1/1storm-co...
As we know we can make a root primary and root secondary of all VLANs of some VLANs with two switches but my concern is can we use the same priorities values for different VLANs for making root primary and secondary on the different switch or on the ...
I mean to say trunk on the switch port . well, I don't know if there's an option on the server interface option to config access/trunk. if there is then might be a problem there
The following pic shows the power budgeting on switch 1, if you see allocated power in Powerstack-1 I think it's more than usual can we edit it or any other suggestion
