About yiwang0030

yiwang0030 · 01-14-2013

Hi all,I found out using extended access list on outbound distribute-list doesn't work as long as the source address in the access-list is not set to 'any'.(2.2.2.2/24) Lo0 R2 F0/0(12.0.0.2/24) ----------- (12.0.0.1/24)F0/0 R1 F0/1(13.0.0.1/24) -----...

yiwang0030 · 01-18-2013

Hi Peter,One more question. There are few arguments (bgp, connected, eigrp, ospf, rip, static) are missing between inbound and outbound .R7(config-router)#distribute-list 101 out ? Async Async interface BVI Bridge-Group ...

yiwang0030 · 01-16-2013

Hi PeterThanks for your reply, thats what I'm looking for.Regarding to "10.0.12.2" is the "source IP" as seen by the ACL. This input value will be set to the next hop address of the received route. Not that this may either be the source address of ...

yiwang0030 · 01-15-2013

Hi John,Thanks for your reply.access-list 101 permit ip host 0.0.0.0 host 1.1.1.0 only filter destinations which make no difference with a standard access-list.I believe it has same effect with my: access-list 101 permit ip any host any, just simply...

yiwang0030 · 01-15-2013

Hi Cadet,Yes, I noticed the source on R3 is 13.0.0.1.I also try using 13.0.0.1 as the source address instead of 12.0.0.2 in that extended access, same issue, R3 will not have any rip route installed.Thanks for your reply!Yi

Member Since	‎01-14-2013 07:09 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	6

User Statistics

User Activity

Extended access-list used on outbound Distribute-list doesn't work in RIP

Re: Extended access-list used on outbound Distribute-list doesn'

Re: Extended access-list used on outbound Distribute-list doesn'

Re: Extended access-list used on outbound Distribute-list doesn'

Extended access-list used on outbound Distribute-list doesn't wo