it
Level 1
Level 1
Member since ‎11-12-2009
‎06-23-2020

User Statistics

  • 30 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 6 Helpful votes Received
Recent Badges
1 Helpful Vote
10 Replies
5 Replies

User Activity

Hi everyone!I have a Cisco 2801 with a 4 port Layer2 switch card installed (HWIC-4ESW).How do I bridge Ethernet0/1 to the 4ESW so if you were to plug a computer into the 4ESW, it would be on the same network as Eth0/1?  Please see my config below:int...
Hi Everyone,I have sort of a conundrum.I have two sites:  Site 1 is the Corporate HQ and Site 2 is located nearby.  The two sites are connected via a layer 2 wireless bridge and Site 2 has a backup cable internet connection in case the wifi bridge go...
Hi everyone,I'm planning a failover ASA deployment and I'm going by this guide:  http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtmlIn the diagram for "LAN-Based Active/Stanby Failover Configurat...
Hi Everyone,I'm trying to gather netflow data over an IPSEC VPN and through my research I've learned that I need to configure Flexible Netflow.  However, I have a Cisco 2801 router with the latest ROMMON and IOS and the Flexible Netflow options aren'...
I'm trying to gather netflow data from a router at another site that's linked with an IPSEC VPN.Here's a quick network map:[Collector]------[HQ 2801 router]------[HQ ASA Firewall]-------VPN---------[Remote 2801 router]I'm able to collect netflow data...
Community Statistics
Member Since ‎11-12-2009 02:05 PM
Date Last Visited ‎06-23-2020 06:26 AM
Posts 30
Total Helpful Votes Received 6
Helpful Votes From