About Juljan Plaku

Juljan Plaku · 02-03-2017

Hi I have configured a SIP TLS DNS Zone for external domain calls. I am failing for both inbound and outbound calls. I am making tests with a verified Skype for Business federated sip domain. I have Logs on Edge for both Inbound and Outbound calls,...

Juljan Plaku · 01-12-2017

Hi, I have a Cisco Telepresence sx10 registered to a CUCM 11.5. The telepresence works fine internally with devices registered with CUCM. So I configured Expressway-C/E. I created a DNS zone which gives access to calls at any domain. I tested the c...

Juljan Plaku · 01-10-2017

Hello everyone I have CSF devices and a sx10 registered to the CUCM. Can I make a video Call from Jabber to sx10? AS far as I tried I cn make Audio Calls but not Video as video is not displayed. What do I need in order to make video calls? Thank You

Juljan Plaku · 09-23-2015

Hi I have a customer with 15 sites connecting with Mikrotik Router-Board . Will I have any issue implementing in this network a video conference solution with:15 Telepresence SX10 one for each sitesCUCMCisco Telepresence ServerCisco Telepresence Cond...

Juljan Plaku · 09-19-2015

HelloI am designing a video conference service project with a client having 16 sites an a headquarter.I have decided to go with telepresence sx 20 or 80 codec.Since it is my first cisco collaboration project, I need to consult some documents or have ...

Juljan Plaku · 02-15-2017

Hi Amar, Thank You for your reply. What about the configuration? DO I need to set the Expressway Edge to Sip Tls only, or do I have to set the Traversal zone from Expressway-C to Expressway-E and the Sip trunk from CUCM to Expressway-C to tls? What ...

Juljan Plaku · 01-12-2017

Hi Jaime, Can you please advice on how to use the device as standalone? Do I have to Nat SIP traffic to the Device's Ip or to use a public Ip for the Device? On the other hand, Should I use a SIp address or direct ip? What record on external DNS do ...

Juljan Plaku · 01-11-2017

Hi Manish Media Termination Point Required box should be unchecked on SX10 config page did the trick. Thank You

Juljan Plaku · 10-06-2015

What if I change the Cisco Telepresence MCU 5300 series with LIC-TP-SMPCisco shared multiparty license, I would end up with:17xSX10CUCM 17xLIC-TP-11X-ROOM1xLIC-TP-SMP 1x Cisco Telepresence Server. It would cost me less, I suppose

Juljan Plaku · 09-23-2015

Hi, Thanks a lot. Is this a good solution in financial terms? What would be best for video conference multiparty solution on 15 sites?

Member Since	‎08-01-2011 03:06 AM
Date Last Visited	‎05-02-2018 12:45 AM
Posts	27

User Statistics

User Activity

Expressway Edge Outbound call failing with Search Completed Reason Not Found

Configure Telepresence SX10 for external SIP calls

Make a Call from Jabber to Telepresence sx10

Mirotik Router-board with Telepresence SX10 CUCM/Telep Server/ Telep Conductor

Telepresence SX Gatekepers and Gateways

Hi Amar,

Hi Jaime,

Hi Manish

What if I change the Cisco

Hi, Thanks a lot. Is this a