Hi,we have problem with ACS 3.2(Win2k):2 days before, ACS starts logging messages "Service CSAuth has been stopped or paused by the system". Occurence is random and frequent. No changes on system done. Any ideas?Thanks for helpStepan03/24/2005,17:27:...
Hello,when downloading module serial numbers via snmp from routers we get some wrong results.We are asking here:iso(1).org(3).dod(6).internet(1).private(4).enterprises(1).cisco(9).temporary(3).chassis(6).cardTable(11).cardTableEntry(1).cardSerial(4)W...
Hello, I have this problem: In one of cca 200 Vlans on network, there is sometimes intermittent connectivity. The outage is about 1-3 s long, once per cca 30-60s -random. Userc can not neither ping their default gateway nor other users in vlan. This ...
Hello, I have suspiction (low performance), that my encryption aim is not running. If i type "show crypto engine accelerator brief" the output contains:" crypto engine name: unknown crypto engine type: ISA/ISM... crypto engine ...
Hello,
Floating L3out is a bit tricky...
Floating IP address shouldn't be used for routing. Create secondary ip address, the same IP on all leafs, and use this one as a next hop on external router. This is described in https://www.cisco.com/c/en/us/t...
Hello,
1)if you do not have use for mgmt ports, you can use these ports (and mgmt vrf) for keepalives. Then you can use different VLAN/VRF/ports for management access.
2)if you normally like to use mgmt ports for mgmt/oob access - do so. Then use dif...
Hi,
I would recommend to not use enable password. Use enable secret instead, because enable password is unencrypted in config printout. If you have both enable password and enable secret , enable password is not effectively working and enable secret ...
