Hi Team,When I am trying to create BGP session with Router A to Router B the IPv6 session is not getting established.In Router A, i have created the session in Global routing table and in Router B, i have used VRF.For IPv4 and IPv6 Session from Route...

Hi Team, Is there any specific command to check the TCAM Utilization of NCS 5500 Routers. Router Model : NCS 55a1/ NCS 55a2/ NCS 5504/ NCS 5508 IOS 6.5.2 Thanks in advance  Regards,Akshay

Hi Team, Was trying to view the BGP up-down logs in the EPNM by bringing down the bgp peer, but its not getting captured. Alarm Code  : BGP-5-ADJCHANGE_DOWNEPNM Version : 3.0.2.0 All other logs are getting captured and snmp is enabled for getting the...

Hi Team, There is requirement to check whether the new Alarm monitoring System in the network is able to capture all the new alarms generated in the nodes. For that we need to generate the alarms in the lab test node integrated with the alarm monitor...