Hi Dennis, This was some years ago, my network has changed since then. The L3 routing is done in the EIGRP process, and the VLAN's are cross-connected to the DMVPN Tunnel interfaces. Today I use Loopback interfaces for the XConnect's, and the Loopbac...
Hi again,I got my L2TPv3 tunnels working between my cisco 891 and my 881 routers.Try to take a look the 'Can't connect VLAN intfc on 881 to l2tpv3 pseudowire' under[WAN, Routing and Switching]https://supportforums.cisco.com/message/3833636#3833636Be...
Hi Patrick,I'm glad you got it working. I'll try out the 'dot1q-tunneling' when I get my lab routers setup.(I really wish that Cisco had a Step-by-Step guide on this stuff).Best regards,Claus
Hi Patrick,I have had a lot of problems getting L2TPv3 to work between my 800-series routers over time.881 <-> 881, 881 <-> 887 and 881 <-> 891 It appears that Cisco have different ways of doing L2TPv3 depending on the platform and the IOS version.F...
Hi again,I just upgraded my 891 IOS firmware to 15.2(4)M1, and now the xconnect command, under interface vlan, is available.But now the xconnect command, under interface FastEthernet, is gone ???????????????I have not had time to test the L2TPv3 tun...