About Vijay Anand

Vijay Anand · 09-28-2017

Hi there, I have query on one of the sip trunk setup: i have two sip trunk from cucm connected to 2 cube manged by service provider.cucm pub, sub 1, sub 2 so in cucm 2 trunk configured and sip trunk 1 points to cube 1 and cube 2 and sip trunk 2 point...

Vijay Anand · 07-26-2016

Hi All, I have a situation where IP phone are configured with two lines, second in common on multiple phones. For first line everything is working fine but for second line dtmf is not working. call are going out through SIP trunk. do any body have...

Vijay Anand · 07-21-2016

hi all, i have strange situtation, i have a cme configured with sip deskphone and SCCP wireless phone in a hunt group. pilot 3527 ------- --- CME ----------------- FXS/FXO---------ISDN -----------------mobile for incoming call it hits the FXO port an...

Vijay Anand · 06-09-2016

Hi All, I was wondering how we can create pre configured template of contact list for jabber. so that jabber load the template of contact list for all user using jabber. Is there any way to acheive it or not. we have imported contact list to cucm,...

Vijay Anand · 05-19-2016

Hi All, I came across an issue where users are not able to dial 800 toll free numbers. They are using CME and sip trunk to provider. when they are dialling 0800XXXXXXX getting busy signal not connecting. for test, we tried calling 8001248888 fr...

Vijay Anand · 05-19-2016

Thanks Vivek, I follow as per your suggestion, i guess service provider is not allowing the 800 calls. as per log below. I checked the configuration for CME, there was missing dial peer for dialling toll free 800 numbers, after adding the dial peer,...

Vijay Anand · 05-17-2016

it is same, when dialing the vm 5600 from other phones without pressing button.

Vijay Anand · 05-16-2016

Hi Deepak, Thank you for your reply. I followed the same video for setting up the VM. All configuration are good, even restarted the cuc. issue occurring internally when i am pressing vm button of phone to dial vm pilot number. it dials pilot numb...

Vijay Anand · 04-01-2016

Hi James, config guide helped to correct the incoming call translation rule, now incoming are working fine. But i have not able to make outbound calls. Here a scenarion: i have 7821 phone dialling international number 0.00393450462650 it waits 3 s...

Vijay Anand · 03-30-2016

Hey Nadeem, I resolved the issue..... Thanks for your explanation above which helped to figure out the cause. I re-read the sip messages and found that call manager was sending the bye message as it was not able to negotiate the codec it was receivi...

Member Since	‎09-14-2011 11:02 AM
Date Last Visited	‎11-22-2017 09:16 PM
Posts	19
Total Helpful Votes Received	5

User Statistics

User Activity

SIP trunk incoming call

DTMF on second line of IP phone 7945 7960 no working

voice port keeps ringing after disconnect

Cisco Jabber contact Template

not able to dial 800 toll free numbers

Thanks Vivek,

it is same, when dialing the

Hi Deepak,

Hi James,

Hey Nadeem,