Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi to everyone,The current version of CCM is 4.2(1)SR1b and the requirement here is to support 7942G and 7937G phone models. It would be greatful if you guys help me here to find out the exact stable CCM version to support both phone models. thankssi...
Dear allCisco 1841 router with VWIC-1MFT-G703 card , old cards getting error , so we planned replace new VWIC-1MFT-G703 , its detecting but line protocol was down , than we changed another cards also same status ,Physical loop given ( PIn out 1 and 4...
Hi to everyone,It would be greatful if you guys guide me here pls..Can we run both mgcp and h323 protocols in a single voice 3845 gateway router ?thanksshiv
Hi to everyone,It would be greatful if you guys guide me here to overcome the strange problem.I configured extension mobility with 2 lines on cisco ip phone 7940s.The problem is when i logged in ,it says logged in successfully but 1st line appears no...
Hi Rob,Thanks for your immediate reply.Here am summarizing,7937G - 4.2(3)SR2 (DevPack-36 or later)7942G - 4.2(3)SR2bWhat i understand here is, i can upgrade to 4.2(3)SR2b with DevPack-36 or later to support 7937G ; pls correct me if am wrong ?Second...
Hi,we tried three new card same status , 3 card are view in show diag command , but line protocol down , same slot Old is working with errors.Physical loop -- > it Line Protocol UP ,, ( after remove the Frame-relay encapsulation ) ,
hi,Thanks for your quick response ... i configured a new template with two lines and assigned it properly as you said..still 2nd line is not appearing when i logged in..any other ideas pls..shiv
