About scottsa

scottsa · 12-31-2002

Hi all,i am looking for OID strings for use with MRTG. i specifically want to monitor backplane utilization, cpu usage, and anything else necessary on a Catalyst 4506 with supervisor II. i searched cisco as well as the internet but was unable to fi...

scottsa · 12-27-2002

This might not be the correct location to post this but is there any type of naming conventions when naming routers and switches?

scottsa · 12-24-2002

i am going to be setting up a 4506 with a sup II and had a few questions:in the best practices guide, it recommends that user data not be on vlan 1, what is the best way to achieve this while still being able to manage the switch. also, i noticed th...

scottsa · 12-31-2002

we didn't purchase it yet, it should be in next month, i assume it will be running catOS since the quote says part number SC4K-SUPK9-7.4.1 description Catalyst 4K Supervisor Flash Imagei looked over the best practices for the 4000 and notice that th...

scottsa · 12-24-2002

thanks for your help

scottsa · 12-24-2002

one last question, just to make sure that i understand:lets say i have the following:user network:VLAN210.0.0.0/24Management network:VLAN110.0.1.0/24switch inband management:10.0.1.1Management Box (with syslog, bb4 (similar to whats up), mrtg (snmp))...

scottsa · 12-24-2002

thanks Erum, i understand about the switchacceleration but i have one more question on the vlans. if i was to create a vlan (vlan2) to put all of the data traffic ports on, this would separate it from the management vlan (vlan1) would i be able to h...

Member Since	‎12-23-2002 11:47 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	7

User Statistics

User Activity

OID Strings for a cat4506 supII for use with MRTG

Naming Conventions

newbie question on the cat 4506

Re: OID Strings for a cat4506 supII for use with MRTG

Re: newbie question on the cat 4506

Re: newbie question on the cat 4506

Re: newbie question on the cat 4506