About pinnacledata

pinnacledata · 09-22-2011

Hello there,We have a location that currently has one frame T1 and 4 point-to-point T1s. We are looking at adding a second frame T1 to be bonded with the first. Currently, we have an old 3640 router, so I am thinking this would be a good time for an ...

pinnacledata · 12-10-2010

This is kind of crazy, but is it possible to connect wire pairs between two locations (ordered from local telco) if we only have 2 wires (1 set of cable pairs) rather than 4 wires (2 sets of cable pairs)? If we had 4 wires, we could use T1 WICs but w...

pinnacledata · 05-19-2005

We have a 7206 as the core router in our network. We have a frame DS3 running off it, and all the remote routers have frame T1s connecting to it. I want to implement OSPF as our routing protocol. In order to get the OSPF adjacency to work, I had to c...

pinnacledata · 01-31-2005

A weird thing has been happening with the past few Catalyst 2950 switches we have ordered... we are unable to telnet into them because the password is invalid. Has anyone else experienced this? We are using the same configuration as always (see below...

pinnacledata · 08-31-2004

Just configuring server load balancing for the first time and see packets dropped when I do 'sh ip slb stats'. Any ideas on things to look at to troubleshoot this? Thank you!108q6509#sh ip slb statsPkts via normal switching: 11859Pkts via special...

pinnacledata · 12-10-2010

Thank you for your response. This sounded promising. I tried looking into that but those options don't exist with the T1 WIC in there. It looks like you need a DSL WIC to get these configuration options.

pinnacledata · 05-20-2005

Thank you very much! That makes me feel better. You are right, we pretty much just have IP traffic, so what you are saying makes sense. Thank you for taking the time to reply.Steve

pinnacledata · 01-31-2005

You are a genius!! I thought about a space before the password, but not after. Not sure why, but that did not occur to me. That was the answer, I am in now!! Thank you, thank you!!

pinnacledata · 08-31-2004

You can do SLB on a 6500 without a special module, but you need to be in native mode (not hydrid). Not sure if you can do SLB on lower end Catalysts or not.

pinnacledata · 08-26-2004

Yes, that is right. I thought the module would give me a link light with the GBIC installed. I was just being dumb. I made a crossover and connected it to another switch, not I have a link light and life is good! Thank you for steering me in the righ...

Member Since	‎04-13-2004 06:17 AM
Date Last Visited	‎07-04-2018 12:05 AM
Posts	19

User Statistics

User Activity

Need router setup for 6 T1 (2 bonded, other 4 are point-to-point T1s)

Any way to connect 2 wire cable pairs from phone company to router?

Had to change MTU size on DS3 to 1500 for OSPF... trouble?

2950 vty password not working

SLB pkts dropped

Re: Any way to connect 2 wire cable pairs from phone company to

Re: Had to change MTU size on DS3 to 1500 for OSPF... trouble?

Re: 2950 vty password not working

Re: Server load balancing

Re: 6509 SUP2 no link light with GBIC plugged in