About alison.hou

alison.hou · 07-29-2019

I tried to use ports not in suppervisor modules for HSRP peers of two 4507r+e switches and could not bring the ports up. can you tell me why? do i have to use ports on the sups. please provide docs if possible. i could not find any. thanks,Alison

alison.hou · 02-08-2019

Cisco document indicated that the switch must be running the LAN Base image to use the following QoS features: Policy mapsPolicing and markingMapping tablesWTD if my switch's image is C2960X-UNIVERSALK9-M, will policy-map ( marking traffic) work? ...

alison.hou · 12-12-2018

I could not find docs from Cisco about how to configure qos on cisco 3650 switch. what are the commands to enable qos in global configuration? how to trust dscp in an interface? my switch is WS-C3650-48PQ. the software is 03.07.04E. THANKS, Al...

alison.hou · 02-17-2017

can I insert HWIC-2FE when it is online? thanks,

alison.hou · 09-16-2015

we had an issue with our MPLS circuit. the Provider asked we check our equipment. The interface was up but there were a lot of input errors. we swapped the cable and cleared the counters. we still saw a lot of errors. see below. I ran show controlle...

alison.hou · 07-30-2019

it is very helpful, Mark. i will check them out after i make sure the physical is up. i think i might figure out why the ports showed dead. Now I remeber we did have spanning-tree bpdugard enable in global. I think the peer ports could be err-disab...

alison.hou · 07-30-2019

it is very helpful, Mark. i will check them out after i make sure the physical is up. i think i might figure out why the ports showed dead. Now I remeber we did have spanning-tree bpdugard enable in global. I think the peer ports could be err-disab...

alison.hou · 07-30-2019

thank you for confirming. i will setup a lab to test it. Alison

alison.hou · 07-30-2019

what does "the layer 2 setup is not being blocked inpath between the devices" mean?thanks,Alison

alison.hou · 07-30-2019

what does "the layer 2 setup is not being blocked inpath between the devices" mean?thanks,Alison

Member Since	‎06-28-2010 06:14 AM
Date Last Visited	‎09-18-2023 09:41 AM
Posts	76
Total Helpful Votes Received	5

User Statistics

User Activity

Can you use any ports for HSRP peers of 4507r+e

REstrictions for QOS for Catalyst 2960-x switch

WS-C3650-48PQ qos configuration

is HWIC-2FE hot swap-table for cisco 2921 router?

Router Ethernet Interface errors

Re: Can you use any ports for HSRP peers of 4507r+e

Re: Can you use any ports for HSRP peers of 4507r+e

Re: Can you use any ports for HSRP peers of 4507r+e

Re: Can you use any ports for HSRP peers of 4507r+e

Re: Can you use any ports for HSRP peers of 4507r+e