About bassomarco1998

bassomarco1998 · 11-13-2024

Hi everyone,While deploying ISE 3.3 on VMware, I encountered an unusual issue. When I entered the "setup" command, there was no response. I’ve tried resetting the VM, rebooting it, and even powering it off and back on, but the problem persists.All th...

bassomarco1998 · 10-17-2024

Hi all,I'm encountering an unusual issue with the Guest authentication process. We have a sponsor portal where each guest registering is assigned the "Self_Guest" type.We've configured the "Self_Guest" user type to store client MAC addresses in a spe...

bassomarco1998 · 10-02-2024

Hi all,We need to retrieve logs related to recent changes in the Network Device Group settings. I have already checked the "Message Catalog" section, but I couldn’t find anything useful due to the large number of entries (over 2,000).Do you know if t...

bassomarco1998 · 09-26-2024

Hi all,We are running a Cisco ISE 3.1P8 cluster with over 20 nodes and are planning to renew the Admin certificates across all nodes, including the Primary Policy Administration Node (PPAN). While reviewing Cisco documentation, I’ve encountered some ...

bassomarco1998 · 08-14-2024

Hello,i'm experiencing an odd behavior from a C9500-24YC stack (SVL) running 17.9.4a firmware version. The stack acts as a gateway for VLAN 1 (192.168.10.17). When i try to ping another client within the same VLAN the ping does not work. Below you ca...

bassomarco1998 · 11-14-2024

UPDATE: After several attempts, we downloaded the OVA file again and verified that the hash matched the one listed on the Cisco portal. After redeploying, we confirmed that the setup wizard now works as expected.It’s likely that the previously downlo...

bassomarco1998 · 11-13-2024

FYI: we redeployed the vm and tried to enter the setup menu through both web and remote console and nothing happened.When I enter "setup" and press Enter, it simply returns to the login prompt repeatedly without any response.

bassomarco1998 · 11-13-2024

FYI: we redeployed the vm and tried to enter the setup menu through both web and remote console and nothing happened.EsXi: 7.0.3 build 24026615.The size node is the following:CPU : 16 vCPURAM : 32 GBDisk : 600 GB

bassomarco1998 · 10-11-2024

Update: We have uploaded and activated the Admin certificate on all nodes, including in the PPAN. After the PPAN rebooted itself, the other nodes did not reboot; therefore, the reboot scope is limited only to that node.It would be interesting to unde...

bassomarco1998 · 10-02-2024

Thanks, @balaji.bandi. I’ve just exported the report from the "Adaptive Network Control Audit" section. However, I noticed that I can only retrieve data starting from the beginning of SeptemberDo you know the maximum retention period for these report...

Member Since	‎09-25-2021 12:21 AM
Date Last Visited	‎09-30-2024 01:23 AM
Posts	37
Total Helpful Votes Received	5

User Statistics

User Activity

Setup wizard not working for virtualized ISE 3.3

Guest's client not assigned to Endpoint Group as per Guest User config

Log messages about Network Device Group changes

Cisco ISE 3.1 – Scope of Reboot for Admin Certificate Renewal

Ping not working even if ARP entry exist

Re: Setup wizard not working for virtualized ISE 3.3

Re: Setup wizard not working for virtualized ISE 3.3

Re: Setup wizard not working for virtualized ISE 3.3

Re: Cisco ISE 3.1 – Scope of Reboot for Admin Certificate Renewal

Re: Log messages about Network Device Group changes