Hi Kope, Each logging message has a default severity level associated with it. You can change that default behavior so that a message is sent based on a configurable severity level instead. For the messages that have a higher default level and that w...
Fernando, The issue here is that the management interface subnet is not included in the cryto access-list as well as the nat exempt access-list. You need to change the crytop access-list and nat-exempt access-list on both the ASAs. You need to ch...
Fernando,Do add the command "Fixup protocol ICMP" which enables ICMP inspection on the ASA, and then try to ping the interface. What exactly happens when you try to access the ASDM on the management interface ?
Thats ok Fernando you just need to enter the following commands:ASA(config)#mangement access management //management is the name of the interface.ASA(config)# http 10.10.10.0 255.255.255.0 managementASA(config)#http ...
Hi Fernando, When we try to access the ASDM on the inside interface of the ASA through an IPSEC tunnel(if the tunnel is terminating on any interface other than inside) you need to add the following commands:ASA(config)management access insideASA(...
